[english] [deutsch] [française]
Humidity Chamber HCP
Cell washing system |
| Universal
ovens Incubators Sterilisers CO2 Incubators Cooled Incubators Humidity Chamber Fridge/Freezers Vacuum Drying Ovens |
Hettich AGSeestrasse 204a |
[HCP humidity chamber] [Accessories HCP] [Overall view HCP]
Memmert-Humidity Chamber HCP
| Model | HCP 108 | HCP 153 | HCP 246 | ||
| Stainless steel interior (deep-drawn electropolished) | Volume | approx. l | 108 | 153 | 246 |
| With/Height/Depth (less 25 mm for air duct in the middle of the back wall) | mm | 560/480/400 | 480/640/500 | 640/640/600 | |
| Provision for sliding stainless steel shelves resp. wire grid shelves | number | 4 | 6 | 6 | |
| Stainless-steel exterior (rear zinc-plated steel) | Width | mm | 710 | 630 | 790 |
| Height | mm | 778 | 938 | 938 | |
| Depth (without door handle, depth of handle 38 mm) | mm | 550 | 650 | 750 | |
| Fully insulated, heated stainless steel door | x | x | x | ||
| Extra internal glass door | x | x | x | ||
| Ventilation | Uniform atmosphere and temperature distribution through enclosed non-turbulent ventilation system, fully covered by the sterilisation process | x | x | x | |
| Humidity | Capacitive humidity sensor (sterilisable) | x | x | x | |
| Active microprocessor control for humidifying and dehumidifying (20-95 % rh), incl. digital indication and auto-diagnostic system ensures even more rapid reaching of set humidity and very short recovery times while avoiding condensate formation; humidity supply with distilled water (from an external tank) by a self-priming pump; integral bacteria block by generating hotsteam, dehumidifying via sterile filter | x | x | x | ||
| Temperature | Electronic microprocessor temperature controller with PT 100 and auto-diagnostic system | x | x | x | |
| Temperatures sensor PT100 Class A in 4-wire circuit for uninterrupted operation on failure of one PT100 with warning indication | double | double | double | ||
| Temperature range with
humidity control: Temperature range without humidity control: (during sterilisation the temperature is fixed at 160 °C - set value)) |
°C °C |
from 20 up to
90 from 20 up to 160 |
from 20 up to 90 |
from 20 up to
90 from 20 up to 160 |
|
| Temperature
fluctuations with time Temperature variation in chamber at 90 °C |
°C °C |
£
± 0,1 £ ± 0,5 |
£
± 0,1 £ ± 0,5
|
£
± 0,1 £ ± 0,5 |
|
| Sterilisation | STERICard for automatic chamber sterilisation cycle 4 h at 160 °C (not for sterilising the load) | x | x | x | |
| Humidity | Capacitive humidity sensor (sterilisable) | x | x | x | |
| Active microprocessor control for humidifying and dehumidifying (20-95 % rh), incl. digital indication and auto-diagnostic system ensures even more rapid reaching of set humidity and very short recovery times while avoiding condensate formation; humidity supply with distilled water (from an external tank) by a self-priming pump; integral bacteria block by generating hotsteam, dehumidifying via sterile filter | x | x | x | ||
| Monitor | Microprocessor temperature monitor acting as overtemperature protection, with PT 100 incorporating fault diagnostics with visual and audible alarm | x | x | x | |
| Digital over- and under-temperature monitor | x | x | x | ||
| Relay for reliable heating cut-off in case of fault | x | x | x | ||
| Mechanical temperature limiter (TB) | x | x | x | ||
| Audible alarm: Over- and undertemperature; over-/underhumidity: open door and empty water tank | x | x | x | ||
| Setpoint linked gliding automatic safety function | x | x | x | ||
| Timer functions | Timer with residual running time: max. 40 ramps (each 1 min. up to 999 h) programmable through controller or MEMoryCard XL; programming via PC and free-of-charge software: unlimited number of ramps | x | x | x | |
| Real-time/weekly programmer with group function | x | x | x | ||
| Documentation | Internal documentation memory 1024 kB as ring memory for all setpoints, actual values, errors, settings with real-time and date; capacity approx. 3 months at 1 min. intervals | x | x | x | |
| Parallel printer interface for printing documentation data, suitable for all PCL3-compatible ink jet printers | x | x | x | ||
| "Celsius 2007" software for control and documentation of temperature and relative humidity | x | x | x | ||
| Setup | Calibration (no separate PC required): Temperature: 3-point calibration on controller; Humidity: 2-points calibration at 20 % and 90 % | x | x | x | |
| Setting of language for dialogue resp. display | x | x | x | ||
| Further data | Electrical supply | V/Hz | 230 / 50/60 | 230 / 50/60 | 230 / 50/60 |
| Electrical load | approx. W | 1000 | 1500 | 2000 | |
| Net weight | approx. kg | 70 | 82 | 110 | |
| Standard accessories | Stainless steel sliding shelves | number | 2 | 2 | 2 |
| Shelf or wire grid shelf width | approx. mm | 560 | 480 | 640 | |
| Shelf depth | approx. mm | 300 | 400 | 500 | |
| Works calibration certificate (test point chamber centre at 60 °C) | x | x | x | ||
|
|
x = Standard model, basic equipment | ||||
Powered by UPLink
optimized for Netscape and IE Version 4
optimized for Netscape and IE Version 4
Donnerstag, 29. März 2007 13:55